Cisco Cisco Voice Interface Cards Installation Guide
Connecting Cisco 2-Port FXS-E/DID Voice Interface Cards
Cisco 2-Port FXS-E/DID Card LEDs
2
Cisco IOS Release 12.4(15)XZ
OL-14874-01
Cisco voice interface cards (VICs) support voice technologies. VICs can be installed in interface card
slots on supported Cisco access routers or in 1- or 2-slot voice network modules that are installed in
network module slots on supported Cisco access routers.
slots on supported Cisco access routers or in 1- or 2-slot voice network modules that are installed in
network module slots on supported Cisco access routers.
A Foreign Exchange Station (FXS)/Direct Inward Dialing (DID) interface connects directly to a standard
telephone, fax machine, or similar device. This interface supplies ringing voltage, dial tone, and so on
to the station.
telephone, fax machine, or similar device. This interface supplies ringing voltage, dial tone, and so on
to the station.
shows the Cisco 2-port FXS-E/DID voice interface card.
Figure 1
Cisco 2-Port FXS-E/DID VIC Front Panel (VIC3-2FXS-E/DID)
Cisco 2-Port FXS-E/DID Card LEDs
The Cisco 2-port FXS-E/DID VIC has one IN USE LED for each port.
describes the functions
of the LEDs.
Supported Platforms
This Cisco voice interface card (VIC3-2FXS-E/DID) is supported on the following Cisco routers:
•
Cisco 2800 series routers, including the Cisco 2801, Cisco 2811, Cisco 2821, and Cisco 2851
•
Cisco 3800 series routers, including the Cisco 3825 and Cisco 3845
•
Cisco IAD2430 series routers
Note
Use Cisco Feature Navigator to find information about platform support and Cisco IOS software image
support. Access Cisco Feature Navigator at
support. Access Cisco Feature Navigator at
. You must have an account on
Cisco.com. If you do not have an account or have forgotten your username or password, click Cancel at
the login dialog box and follow the instructions that appear.
the login dialog box and follow the instructions that appear.
Before connecting a VIC to the network, ensure that the VIC is installed in the router, the equipment is
properly grounded, and you have the proper cables for connecting the VIC to the network. This section
describes the preparation necessary before connecting a 2-port FXS-E/DID VIC to the network.
properly grounded, and you have the proper cables for connecting the VIC to the network. This section
describes the preparation necessary before connecting a 2-port FXS-E/DID VIC to the network.
231537
2FXS-E/DID
Table 1
Cisco 2-Port FXS-E/DID VIC LEDs
LED status
Description
Green
Monitored port is active (has initialized without error).
Yellow
Monitored port is not ready.
Off
Monitored port is not active (has failed to initialize).