Cisco Cisco TelePresence Management Suite (TMS) Version 15
Testing provisioning with E20
Cisco TMS Provisioning Deployment Guide
Page 43 of 47
Testing provisioning with E20
To make the provisioning scheme work, the E20 endpoint must be set up with a username, password,
domain, and external manager address. These parameters can be entered into the provisioning wizard of
the E20 during the first startup of the device:
domain, and external manager address. These parameters can be entered into the provisioning wizard of
the E20 during the first startup of the device:
Configuring the endpoint
1. Connect the E20 to a LAN.
2. Go to
2. Go to
Settings > Configure your E20
.
3. Enter the username and password you have created. (See
.)
4. The Domain should be identical to the SIP domain configured on the Cisco VCS.
5. Enter the Cisco VCS address as External Manager. Press OK.
5. Enter the Cisco VCS address as External Manager. Press OK.
Verifying that provisioning works
The E20 should now sign in and register. Make sure provisioning data has been received:
1. Verify that the endpoint's URI is visible in the top left corner of the screen.
2. Verify that you can make and receive calls.
3. Check that the phone books provisioned to your user is available on the endpoint.
2. Verify that you can make and receive calls.
3. Check that the phone books provisioned to your user is available on the endpoint.
Note: To troubleshoot issues that may arise, refer to the section
in this document, and to the
Cisco TMS Provisioning Troubleshooting Guide document.