Cisco Cisco TelePresence Management Suite (TMS) Version 15 Installation Guide
Setting up Cisco TelePresence Management Server
Cisco TelePresence Management Suite Installation and Getting Started Guide (13.1)
Page 35 of 75
Installation precautions and hardware
compliances
compliances
Safety precautions:
n
Never install communication wiring during a lightning storm.
n
Never install jacks for communication cables in wet locations unless the jack is specifically designed
for wet locations.
for wet locations.
n
Never touch uninstalled communication wires or terminals unless the communication line has been
disconnected at the network interface.
disconnected at the network interface.
n
Use caution when installing or modifying communication lines.
n
Avoid using communication equipment (other than a cordless type) during an electrical storm. There
may be a remote risk of electrical shock from lightning.
may be a remote risk of electrical shock from lightning.
n
Do not use the communication equipment to report a gas leak in the vicinity of the leak.
n
Always connect the product to an earthed socket outlet.
n
The socket outlet must be installed near to the equipment and be easily accessible.
n
Switch the power OFF before installing cables.
This product complies with the following directives:
n
LVD 73/23/EC, EMC 89/366/EEC, R&TTE 99/5/EEC,
n
Directive 73/23/EEC (Low Voltage Directive)
n
Standard EN 60950-1
n
Directive 89/336/EEC (EMC Directive)
n
Standard EN 55022, Class A
n
Standard EN 55024
n
Standard EN 61000-3-2/-3-3
n
Approved according to UL 60950-1 and CAN/CSA C22.2 No. 60950-1-03
n
Complies with FCC15B Class A
Unpacking
To avoid damage to the unit during transportation, Cisco TelePresence Management Server is delivered
in a special shipping box, which contains the following components:
in a special shipping box, which contains the following components:
n
Rack-ears, screws and screwdriver.
n
Cables:
l
Power cable
l
Ethernet cable
l
Cisco TelePresence Management Server
Installation site preparations
n
Make sure that Cisco TelePresence Management Server is accessible and that all cables can be
easily connected.
easily connected.
n
For ventilation leave a space of at least 10 cm (4 inches) behind the rear panel and 10 cm (4 inches) in
front of the front panel.
front of the front panel.