Cisco Cisco TelePresence Management Suite (TMS) Version 15 Installation Guide
Requirements and prerequisites
Cisco TelePresence Management Suite Installation and Getting Started Guide (13.2)
Page 14 of 77
Upgrade notes
Upgrading Cisco TMS software is handled automatically by the installer, and there is no need to uninstall
previous versions prior to upgrading.
previous versions prior to upgrading.
Review all notes listed below that apply to the version of Cisco TMS you are currently running before starting
your Cisco TMS upgrade.
your Cisco TMS upgrade.
All upgrades
The default Booking Confirm email templates and phrase files have been updated in 13.2. If you have
customized these templates, the new additions are not automatically added to your customized files but are
still available for use. To see the default usage of these new values and have them in your templates,
customers with customized Booking Confirm templates or phrases must use the Revert to Default button in
the
customized these templates, the new additions are not automatically added to your customized files but are
still available for use. To see the default usage of these new values and have them in your templates,
customers with customized Booking Confirm templates or phrases must use the Revert to Default button in
the
Edit Email Template
page. Once defaulted, you can re-add the customizations back into the templates
or phrase files.
Version-specific notes
Versions prior to 13.0
If upgrading from a version prior to 13.0, note that:
n
.NET Framework requirements have changed from 3.5 to 4.0.
n
The Cisco VCS requirement for provisioning has changed to version X5.2 or later.
Version 12.5 and older
DNS reverse lookups (PTR records) that were required in Cisco TMS 12.5, are no longer required. Note that
the same requirement applies to the Cisco VCS. See the Cisco VCS Software Release Notes (X5).
the same requirement applies to the Cisco VCS. See the Cisco VCS Software Release Notes (X5).
Under
Administrative Tools > Configuration > General Settings
, Enable TMS Agents is now set to No
by default. If enabling this setting, we recommend going to
Administrator Tools > TMS Agent
Diagnostics
to confirm that the local TMS Agent shows no errors and that all diagnostic tests are OK.
If any errors are found on the Local Cisco TMS Agent, these errors need to be fixed before proceeding with
replication to the Cisco VCS(s). Refer to the Diagnostic section within the Provisioning Deployment Guide
for troubleshooting any errors found on the Local Cisco TMS Agent or contact your local Cisco partner or
customer support for assistance.
replication to the Cisco VCS(s). Refer to the Diagnostic section within the Provisioning Deployment Guide
for troubleshooting any errors found on the Local Cisco TMS Agent or contact your local Cisco partner or
customer support for assistance.
Versions 12.2 and 12.1
If your installation uses the Cisco TMS Provisioning directory functionality for Cisco Movi deployments and
you are upgrading Cisco TMS from either software version 12.1 or 12.2, you must follow the upgrade
procedures in the document
you are upgrading Cisco TMS from either software version 12.1 or 12.2, you must follow the upgrade
procedures in the document
Caution: Upgrades will be blocked if the procedures found in the deployment guide are not followed
appropriately. The error message will state that Provisioning on all clusters must be disabled before
upgrading.
appropriately. The error message will state that Provisioning on all clusters must be disabled before
upgrading.