Cisco Cisco TelePresence Management Suite (TMS) Version 15 Installation Guide
n
Accessories: Most systems should only be used with a cart, stand, tripod, bracket, or table specified by
the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving cart/apparatus
combination to avoid injury from tip-over.
the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving cart/apparatus
combination to avoid injury from tip-over.
n
Lightning: Unplug apparatus during lightning storms or when unused for long periods of time.
n
Servicing: Do not attempt to service the apparatus yourself as opening or removing covers may expose
you to dangerous voltages or other hazards, and will void the warranty. Refer all servicing to qualified
service personnel.
you to dangerous voltages or other hazards, and will void the warranty. Refer all servicing to qualified
service personnel.
n
Damaged equipment: Unplug apparatus from outlet and refer servicing to qualified personnel under the
following conditions:
following conditions:
l
when power cord or plug is damaged or frayed
l
if liquid has been spilled or objects have fallen into the apparatus
l
if apparatus has been exposed to rain or moisture
l
if apparatus has been dropped and subjected to excessive shock, or cabinet has been damaged
l
if apparatus fails to operate in accordance with the operating instructions
Installation precautions and hardware compliances
Safety precautions:
n
Never install communication wiring during a lightning storm.
n
Never install jacks for communication cables in wet locations unless the jack is specifically designed for
wet locations.
wet locations.
n
Never touch uninstalled communication wires or terminals unless the communication line has been
disconnected at the network interface.
disconnected at the network interface.
n
Use caution when installing or modifying communication lines.
n
Avoid using communication equipment (other than a cordless type) during an electrical storm. There may
be a remote risk of electrical shock from lightning.
be a remote risk of electrical shock from lightning.
n
Do not use the communication equipment to report a gas leak in the vicinity of the leak.
n
Always connect the product to an earthed socket outlet.
n
The socket outlet must be installed near to the equipment and be easily accessible.
n
Switch the power OFF before installing cables.
This product complies with the following directives:
n
LVD 73/23/EC, EMC 89/366/EEC, R&TTE 99/5/EEC,
n
Directive 73/23/EEC (Low Voltage Directive)
n
Standard EN 60950-1
n
Directive 89/336/EEC (EMC Directive)
n
Standard EN 55022, Class A
n
Standard EN 55024
n
Standard EN 61000-3-2/-3-3
n
Approved according to UL 60950-1 and CAN/CSA C22.2 No. 60950-1-03
n
Complies with FCC15B Class A
Cisco TelePresence Management Suite Installation and Upgrade Guide (14.3)
Page 27 of 44
Setting up Cisco TelePresence Management Server