Cisco Cisco TelePresence Management Suite (TMS) Version 15 Maintenance Manual
Field
Description
Send
Warning
When Auto
Attendant
Conferences
Exceed This
Duration (in
seconds)
Warning
When Auto
Attendant
Conferences
Exceed This
Duration (in
seconds)
A conference event is triggered in Conference Control Center when the duration of an MCU Auto
Attendant conference has exceeded the set time limit (in seconds). Set to 0 to disable (no event
will be triggered).
Attendant conference has exceeded the set time limit (in seconds). Set to 0 to disable (no event
will be triggered).
Automatic
MCU Failover
MCU Failover
■
Off: Cisco TMS will not initiate automatic MCU failover.
■
If conference start fails: Cisco TMS will automatically try another MCU if conference setup
fails during conference start.
fails during conference start.
■
If conference start or MCU polling fails: Cisco TMS will automatically try another MCU if
conference setup fails during conference start, or if the MCU is unresponsive during the
conference. For failover threshold, see the field below. We do not recommend using this
setting, as Cisco TMS could disconnect all participants from a conference if the network
connection to the hosting MCU is lost for a short time, despite the conference having
continued with no problem. This setting is ignored for conferences hosted on a
TelePresence Conductor.
conference setup fails during conference start, or if the MCU is unresponsive during the
conference. For failover threshold, see the field below. We do not recommend using this
setting, as Cisco TMS could disconnect all participants from a conference if the network
connection to the hosting MCU is lost for a short time, despite the conference having
continued with no problem. This setting is ignored for conferences hosted on a
TelePresence Conductor.
Note:
Automatic MCU Failover is only supported for scheduled conferences where the main
participant is an MCU or a TelePresence Conductor. It is not supported for cascaded conferences
hosted on direct managed MCUs.
hosted on direct managed MCUs.
Automatic
MCU Failover
Threshold
(seconds
after first poll
failure)
MCU Failover
Threshold
(seconds
after first poll
failure)
Specify the number of seconds Cisco TMS will wait after the first poll failure before MCU failover is
executed.
executed.
Table 145 Settings in the Advanced section (continued)
WebEx Settings
In Cisco TMS: Administrative Tools > Configuration > WebEx Settings
On the WebEx Settings page, you add WebEx sites to Cisco TMS and configure them.
Note that to be able to add WebEx in telepresence conferences, a WebEx Site, WebEx Username, and WebEx
Password must also be set up for each conference owner in Cisco TMS, and your telepresence deployment must be
set up to support CMR Hybrid.
Password must also be set up for each conference owner in Cisco TMS, and your telepresence deployment must be
set up to support CMR Hybrid.
■
.
■
WebEx Configuration
Field
Description
Enable WebEx
■
Yes: Conferences can include Webex.
■
No: Conferences cannot include Webex.
Table 146 General WebEx settings for Cisco TMS
242
Cisco TelePresence Management Suite Administrator Guide
Administrative Tools