Cisco Cisco TelePresence Management Suite (TMS) Version 15 Maintenance Manual
1. For each endpoint:
a. Go to
Device > Phone
and click the endpoint's device name.
b. Assign the same DN (Directory Number) as the IP phone that is associated with this endpoint.
c. At the bottom of the
c. At the bottom of the
Device Information
section, select Allow Control of Device from CTI.
d. In the
Product Specific Configuration Layout
section, enter a dummy email address in the Room
Name field.
This is a mandatory item but any email address can be used.
This is a mandatory item but any email address can be used.
e. In the Directory Number Information section of
Directory Number Configuration
, select Allow
Control of Device from CTI.
f. Set the field SSH AdminLife to 0 to prevent the command-line interface password from expiring.
Cisco TMS uses this password to set up calls.
2. For each IP phone device that is associated to a telepresence device, select Allow Control of Device
from CTI at the bottom of the
Device Information
section.
Endpoints running TE and TC software
Endpoints running TE and TC software must already have been added to the Unified CM as detailed in the
document
document
.
For each endpoint follow these steps in Unified CM:
1. Go to
Device > Phone
and search for the device name corresponding to the telepresence endpoint.
2. At the bottom of the
Product Specific Configuration Layout
section, ensure that Web Access and
SSH Access are set to Enabled.
Adding the systems
Unified CM must be added to Cisco TMS before you can add the endpoints, following these steps:
1. In
Systems > Navigator
go to the folder where you want to add the endpoints.
2. Click Add Systems.
3. Go to the
From List
tab.
4. Click Unified CM.
5. Select the endpoints you want to add.
6. Click Next.
7. Click Finish Adding Systems.
Adding an unmanaged bridge
Cisco TMS supports adding unsupported legacy and third party bridges (including Cisco TelePresence
Multipoint Switch) so they can be scheduled in conferences.
Multipoint Switch) so they can be scheduled in conferences.
Prior to adding an unmanaged bridge to Cisco TMS, you must have created dedicated conferences for use
with Cisco TMS scheduling on the bridge. These are known as Static Meetings on a Cisco TelePresence
Multipoint Switch. Refer to your bridge's documentation for details of how to configure these conferences.
with Cisco TMS scheduling on the bridge. These are known as Static Meetings on a Cisco TelePresence
Multipoint Switch. Refer to your bridge's documentation for details of how to configure these conferences.
To add an unmanaged bridge:
Cisco TelePresence Management Suite Administrator Guide (14.6)
Page 74 of 344
Adding and managing systems
Adding systems