Cisco Cisco TelePresence Management Suite (TMS) Version 15 Maintenance Manual
WebEx Details tab
This tab displays if you have added WebEx Enabled TelePresence to the conference. No details are shown
until the conference has been saved.
until the conference has been saved.
Connection Settings tab
This tab appears after participants are added to the conference and contains information on how the call will
be set up. Depending on the participants, it is possible to change several settings here, including:
be set up. Depending on the participants, it is possible to change several settings here, including:
n
direction of calls.
n
protocol.
n
numbers dialed. Editing the Number field changes the dial string dialed by that participant, but will not
change anything on the remote end, for example allocated ports on MCUs.
change anything on the remote end, for example allocated ports on MCUs.
By clicking on the Settings link to the right of each participant, additional settings can be configured, for
example the bandwidth. For dial-out participants, DTMF Tones can be set in the
example the bandwidth. For dial-out participants, DTMF Tones can be set in the
Number Settings
section.
For conferences with an MCU, it is possible to mute audio and video on connect for each separate
participant.
participant.
Select Main
The Main participant is the system that hosts the conference. This can be either an MCU, or a system with
multisite if there are more than two participants. If the conference is point-to-point then either system can be
the Main. If booking from the Cisco TMS web interface, you can choose which participant you want to be the
Main from the drop-down menu.
multisite if there are more than two participants. If the conference is point-to-point then either system can be
the Main. If booking from the Cisco TMS web interface, you can choose which participant you want to be the
Main from the drop-down menu.
.
Routing
Call direction depends on both conference type and the type of endpoint. For One Button to Push
conferences, the call direction is always from the endpoint.
conferences, the call direction is always from the endpoint.
Cascaded MCU calls and recording calls are always scheduled and initiated by Cisco TMS. For more
information see
information see
Distribution (Routing Modes)
Type
Description
No
distribution
distribution
Only one MCU will be used in the conference.
Table 92: Distribution types
Cisco TelePresence Management Suite Administrator Guide (14.4)
Page 166 of 331
Booking
New Conference