Cisco Cisco TelePresence Management Suite (TMS) Version 15 Maintenance Manual
Permissions
The
Permissions
tab controls permissions for the use and administration of a specific system for Cisco
TMS user groups. The permission levels that can be set are the same as can be set on folders. For details,
see
see
.
Logs
Use this tab to access all available logs for the system.
Log
Description
History All detected changes that have been made to the system in Cisco TMS.
Ticket Log
.
Add Systems
In Cisco TMS:
Systems > Navigator
Add Systems has been clicked
When clicking Add Systems in the
System Navigator
, four different tabs are available:
n
Add Systems
n
From List
n
Pre-register Systems
n
Add Room/Equipment
Add Systems tab
The initial tab to open is
Add Systems
.
Section
Description
Specify
Systems by IP
Addresses or
DNS names
Systems by IP
Addresses or
DNS names
In this field you can enter:
n
single IP addresses or DNS names
n
a range of IP addresses from a start to an end IP-address
n
a comma separated list of IP addresses and host addresses
This means that when entering user.TMS.int, 10.0.0.1, 10.1.1.0 - 10.1.1.10, two systems will be
added (one by DNS name and one by IP address) and ten systems in a range will be scanned.
added (one by DNS name and one by IP address) and ten systems in a range will be scanned.
Enter Location
Settings
Settings
Specify the ISDN zone, IP zone, and time zone.
Advanced
Settings
Settings
Click on the pane heading to expand and collapse this pane, which contains the sections
below.
below.
Set
authentication
settings
authentication
settings
If the system(s) requires authentication, enter the username and password. Do not fill in the
Admin Password field.
Admin Password field.
If adding a recording server or content server, make sure to add the credentials for the API.
Cisco TMS Administrator Guide (14.1)
Page 116 of 320
Adding and managing systems
Navigator