Cisco Cisco MeetingTime Quick Setup Guide

You perform this task in the Cisco Unified Communications Manager Administration pages. 
Because the pages and menus vary by release, you should check the Cisco Unified 
Communications Manager Administration online help for step-by-step instructions that are specific 
to your release.

Go to http://ccm-server/ccmadmin/main.asp, where ccm-server is the fully-qualified domain name or 
IP address of the Cisco Unified Communications Manager server.

Log in with your Cisco Unified Communications Manager administrator username and password.

Select Call Routing > Route/Hunt > Route Pattern.

Select Add New.

Configure the fields described in 

.

Configure all other required fields appropriately for your current deployment. 

For field descriptions, select Help > This Page.

Select Save.

Select OK to any pop-up dialog box messages that you see.

Repeat this procedure as necessary to route calls to each access phone number and DID number for your 
Cisco Unified MeetingPlace system. 

 module 

 module 

Route Pattern

Enter the Cisco Unified MeetingPlace phone number.

Requirements:

This number must not conflict with any other route pattern defined in this 
Cisco Unified Communications Manager cluster.

Do not enter any spaces in this field.

Gateway/Route List

Select the 

 of one of the following, depending on your deployment:

Inter-cluster trunk to the Cisco Unified Communications Manager Release 6.1 
(or a later release) server that provides front-end signaling for Cisco Unified 
MeetingPlace.

(Cisco Unified Communications Manager 5.x only) SIP trunk to the 
Cisco Unified Communications Manager Release 6.1 (or a later release) server 
that provides front-end signaling for Cisco Unified MeetingPlace. 

Call Classification

Select OffNet.