Cisco Cisco MeetingTime Quick Setup Guide

Configure all other required fields appropriately for your current deployment. 

If you configured a Calling Search Space to block unwanted dial-out calls, then apply the Calling Search 
Space accordingly to the SIP trunk.

For field descriptions, select Help > This Page.

Select Save.

Repeat this task so that both of the following servers are configured with SIP trunks that point to each 
other:

Cisco Unified Communications Manager 4.x or 5.x

Cisco Unified Communications Manager 6.1 or a later release

Proceed to the 

Use this procedure to configure route patterns to enable Cisco Unified Communications Manager 4.x or 
5.x to route calls that are placed to Cisco Unified MeetingPlace phone numbers. The route patterns 
associate the Cisco Unified MeetingPlace phone numbers with one of the following, depending on your 
deployment:

Inter-cluster trunk to the Cisco Unified Communications Manager Release 6.1 (or a later release) 
server that provides front-end signaling for Cisco Unified MeetingPlace

(Cisco Unified Communications Manager 5.x only) SIP trunk to the Cisco Unified 
Communications Manager Release 6.1 (or a later release) server that provides front-end signaling 
for Cisco Unified MeetingPlace 

Complete the 

.

Complete one of the following items, depending on your deployment:

Write down each of the following phone numbers from the Cisco Unified MeetingPlace 
Administration Center:

Access phone numbers configured on the 

Direct Inward Dial (DID) numbers—only if you enable DID through the 

 field