Cisco Cisco Unified MeetingPlace Audio Server Quick Setup Guide

 module 

 module 

Proceed to the 

.

Route patterns enable Cisco Unified Communications Manager to route calls to Cisco Unified 
MeetingPlace by associating phone numbers with the SIP trunk. 

Complete the 

Write down each of the following phone numbers from the Cisco Unified MeetingPlace 
Administration Center:

Access phone numbers configured on the 

Direct Inward Dial (DID) numbers—only if you enable DID through the 

 field

You perform this task in the Cisco Unified Communications Manager Administration pages. 
Because the pages and menus vary by release, you should check the Cisco Unified 
Communications Manager Administration online help for step-by-step instructions that are specific 
to your release.

Go to http://ccm-server/, where ccm-server is the fully-qualified domain name or IP address of the 
Cisco Unified Communications Manager server.

Log in with your Cisco Unified Communications Manager administrator username and password.

Select Call Routing > Route/Hunt > Route Pattern.

Select Add New.

Configure the fields described in