Cisco Cisco Unified MeetingPlace Audio Server Quick Setup Guide

If the Administration Center in both nodes displays “Failover deployment. Standby server,” then 
something may have interrupted the process initiated in 

. To resolve this issue, see the 

 command description in the 

 module.

If you switch on replication with sync via the mp_replication switchON command and replication 
fails, it is possible that a table is locking due to the processes on an active server. To resolve this 
issue, run the mp_replication switchON with sync command again. 

During this process, you may see several error messages. These error messages are expected 
behavior and informational only. The final message of the command explicitly says if the command 
ran successfully or not. 

An example of an error message that you can ignore is: 

* Error:

 

'/opt/cisco/meetingplace/database/versions/IIF.10.00.UC5XL/etc/sqlhosts not 

initialized. xxxxxx  is missing'

 

* Forcing the fix

The final message, which indicates if the process was successful, is: 

Database Replication changes for this machine (Host = <hostname>; IP Addr = <ip 

addr>) is SUCCESSFUL

Installation, Upgrade, and Migration Guide for Cisco Unified MeetingPlace at 

 

 module 

Proceed to the 

Whenever you need to configure the Application Server in a failover deployment, use this procedure to 
make sure that both the active and standby servers have the same configuration.

Complete one of the following tasks:

Determine the hostname or IP address of both of the following virtual network interfaces:

eth0:0 of the active server

State: Active 

State: Active 

Status: Local 

Status: Connected