Cisco Headend System Release 2.7 Installation Guide
Appendix C
Direct ASI Installation and Configuration Procedures
118
4023737 Rev C
Shutting Down the SA Application Server
After stopping the SA Application Server, follow these steps to stop the Application
Server.
1 Log on to an xterm window on the Application Server as root user.
Server.
1 Log on to an xterm window on the Application Server as root user.
Note: Alternatively, you can complete this procedure from a remote shell on the
Application Server:
a In a DNCS xterm window, type rsh appserver and press Enter. This will
Application Server:
a In a DNCS xterm window, type rsh appserver and press Enter. This will
open a remote shell on the Application Server.
b Proceed to step 2 and run the command from the remote shell.
2 Type /usr/sbin/shutdown -i0 -g0 -y and then press Enter. The Application
Server shuts down and the ok prompt appears.
Stopping the Application Server at Aptiv Sites
Complete these steps to stop the Application Server at sites that support the Aptiv
resident application.
1 Press the middle mouse button on the Application Server and select Passport
resident application.
1 Press the middle mouse button on the Application Server and select Passport
Stop.
2 From an xterm window on the Application Server, type CheckServices and then
press Enter. A list of drivers appears.
Note: Each driver is associated with an Application Server process.
Note: Each driver is associated with an Application Server process.
3 Wait until the word No appears next to each driver.
4 Log in to an xterm window as root user.
5 Type init 0 and then press Enter. The Application Server shuts down and an ok
4 Log in to an xterm window as root user.
5 Type init 0 and then press Enter. The Application Server shuts down and an ok
prompt appears.
6 Go to Stopping the DNCS (on page 52). Then go to Install the ASI Card (on
page 119).