Cisco Headend System Release 2.7 Installation Guide
Install the ASI Card
4023737 Rev C
119
Install the ASI Card
The Common Download feature requires that a special card be installed in the
DNCS. Sites that support both the Direct ASI feature, as well as the Common
Download feature, may find it convenient to install the Common Download card at
the same time that the Direct ASI card is installed. For this reason, information
pertaining to the Common Download card is included in step 4.
DNCS. Sites that support both the Direct ASI feature, as well as the Common
Download feature, may find it convenient to install the Common Download card at
the same time that the Direct ASI card is installed. For this reason, information
pertaining to the Common Download card is included in step 4.
After deleting (if necessary) the ASI package from the DNCS, follow the instructions
in this section to install the ASI card.
1 Follow these instructions, if necessary, to log in to the xterm window as root
in this section to install the ASI card.
1 Follow these instructions, if necessary, to log in to the xterm window as root
user.
Note: If you had to remove the ASI package in the previous procedure, you
should already be root user.
a Type su - and then press Enter. The password prompt appears.
b Type the root password and then press Enter.
Note: If you had to remove the ASI package in the previous procedure, you
should already be root user.
a Type su - and then press Enter. The password prompt appears.
b Type the root password and then press Enter.
2 Type shutdown -y -g0 -i0 and then press Enter. The DNCS shuts down and the
ok prompt appears.
3 Turn off power to the DNCS.
4 Remove the cover to the DNCS and install the ASI card into one of the following
4 Remove the cover to the DNCS and install the ASI card into one of the following
slots:
For a Enterprise 450 DNCS, Slot 5
For a Sun Fire V880 DNCS, Slot 7
5 Is your site you upgrading to support the common download feature?
If yes, then install the common download card in the following slot:
–
–
For a Sun Fire V880 DNCS, Slot 2
–
For a Enterprise 450 DNCS, Slot 4
If no, go to step 6.
6 Put the cover back on the DNCS.
7 Turn on power to the DNCS.
8 Log on to the DNCS as root user.
9 Did the DNCS processes start after you turned on the power?
7 Turn on power to the DNCS.
8 Log on to the DNCS as root user.
9 Did the DNCS processes start after you turned on the power?
If no, go to Install the ASI Package (on page 120).