Cisco Cisco TelePresence MCU 4510 Maintenance Manual
Configuring network and system settings
Cisco TelePresence MCU 4.3 Product administration guide
Page 179 of 242
ConferenceMe
Enable/disable the ConferenceMe
service on the specified interface
or change the port that is used for
this service.
service on the specified interface
or change the port that is used for
this service.
By changing the port, you can
block access to the web interface
while still allowing users to use
ConferenceMe to join
conferences.
block access to the web interface
while still allowing users to use
ConferenceMe to join
conferences.
If a port is disabled, this option will be unavailable.
See
Using ConferenceMe to join conferences
for more
information on ConferenceMe.
UDP service
SNMP
Enable/disable the receiving of the
SNMP protocol on this port or
change the port that is used for this
service.
SNMP protocol on this port or
change the port that is used for this
service.
If a port is disabled, this option will be unavailable.
If you want to enable the receiving of the SNMP protocol
on Port B, ensure that you have the video firewall as an
activated feature (refer to
on Port B, ensure that you have the video firewall as an
activated feature (refer to
) and you have selected the check box for SNMP on
Port B.
Note that by default SNMP Traps are sent to port UDP
port 162 (on the destination network management
station); this is configurable. For more information, refer
to
port 162 (on the destination network management
station); this is configurable. For more information, refer
to
.
If you require advanced security for the MCU, disable the
SNMP service.
SNMP service.
SIP (UDP)
Allow/reject incoming and
outgoing calls to the MCU using
SIP over UDP or change the port
that is used for this service.
outgoing calls to the MCU using
SIP over UDP or change the port
that is used for this service.
Disabling this option will prevent calls using SIP over
UDP.
UDP.
If a port is disabled, this option will be unavailable.
If you want to allow incoming and outgoing SIP (UDP)
calls on Port B, ensure that you have the video firewall
as an activated feature (refer to
calls on Port B, ensure that you have the video firewall
as an activated feature (refer to
) and you have selected the check box for
SIP (UDP) on Port B.
H.323
gatekeeper
gatekeeper
Enable/disable access to the built-
in H.323 gatekeeper or change the
port that is used for the built-in
H.323 gatekeeper.
in H.323 gatekeeper or change the
port that is used for the built-in
H.323 gatekeeper.
If a port is disabled, this option will be unavailable.
If you want to open Port B for the H.323 gatekeeper,
ensure that you have the video firewall as an activated
feature (refer to
ensure that you have the video firewall as an activated
feature (refer to
)
and you have selected the check box for H.323
gatekeeper on Port B.
gatekeeper on Port B.
Tunneled
media
media
Enable/disable tunneled media
calls to the MCU over UDP
calls to the MCU over UDP
This option must be enabled to allow ConferenceMe to
connect over UDP. This option is only available if you
have the Web Conferencing feature key installed.
connect over UDP. This option is only available if you
have the Web Conferencing feature key installed.
Configuring SNMP settings
To configure monitoring using SNMP, go to
Network > SNMP
.
The MCU sends out an SNMP trap when the device is shut down or started up. The SMNP page allows you
to set various parameters; when you are satisfied with the settings, click Update SNMP settings.
to set various parameters; when you are satisfied with the settings, click Update SNMP settings.
Note that: