Cisco Cisco Catalyst 6000 Multilayer Switch Feature Card MSFC2 Installation Guide
Connecting Cisco IP VSAT Satellite WAN Network Modules to the Network
How to Install, Connect, or Replace the NM-1VSAT-GILAT Network Module
12
Connecting Cisco IP VSAT Satellite WAN Network Modules to the Network
Figure 5
Connecting the NM-1VSAT-GILAT Network Module to the ODU
What to Do Next
Proceed to the
Connecting the NM-1VSAT-GILAT Network Module to the External
Power Supply
Power Supply
This section describes how to connect the NM-1VSAT-GILAT network module to the external
power supply that comes in the “Sat Kit” provided by a Gilat SkyEdge satellite service provider. The
NM-1VSAT-GILAT network module requires additional power to operate the ODU, which includes the
dish antenna and its parts, such as the LNB, SSPA, OMT, and feed horn.
power supply that comes in the “Sat Kit” provided by a Gilat SkyEdge satellite service provider. The
NM-1VSAT-GILAT network module requires additional power to operate the ODU, which includes the
dish antenna and its parts, such as the LNB, SSPA, OMT, and feed horn.
Note
If an installation technician has already connected a power supply to the ODU, then do not perform
this task. Instead, proceed directly to the software configuration tasks for your NM-1VSAT-GILAT
network module. See the
this task. Instead, proceed directly to the software configuration tasks for your NM-1VSAT-GILAT
network module. See the
Cisco IOS feature module.
1
LNB
3
RF-IN connector
2
SSPA
4
RF-OUT connector
127469
NM-1VSAT
GILAT
EN
RF-IN
RF-OUT
ODU PWR
EXT
DC
RE
LOCK SYNC
ON
LINE
TX
3
4
1
2
ODU
IDU