Cisco Cisco Fiber IGESM Switch Module for IBM Release Notes
4
Release Notes for the Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter
43W7806
Upgrading the Switch Software
Deciding Which Files to Download from the Web
lists the software filenames for this release.
Upgrading a Switch by Using the CLI
The upgrade procedure in this section describes how to perform the upgrade by using a combined tar file.
The procedure assumes that you have already downloaded the tar file for this release from ibm.com to
your TFTP server or management station. The tar file is an archive file from which you can extract files
by using the archive download-sw command.
The procedure assumes that you have already downloaded the tar file for this release from ibm.com to
your TFTP server or management station. The tar file is an archive file from which you can extract files
by using the archive download-sw command.
For information about where to access the tar files on ibm.com and the names of the tar files for this
release, see the
release, see the
Caution
Do not power cycle the switch while you are copying an image to the switch. If a power failure occurs
while you are copying the software image to the switch, call your technical support representative
immediately.
while you are copying the software image to the switch, call your technical support representative
immediately.
The upgrade procedure uses the archive download-sw privileged EXEC command to automatically
extract and download the images to the switch. The archive download-sw command automatically
deletes the old version and copies the new version to flash memory if the flash memory does not have
space to store the old and new versions simultaneously. The archive download-sw command initiates
this process:
extract and download the images to the switch. The archive download-sw command automatically
deletes the old version and copies the new version to flash memory if the flash memory does not have
space to store the old and new versions simultaneously. The archive download-sw command initiates
this process:
•
It verifies adequate space on the flash memory before downloading the new image.
•
If there is insufficient space on the flash memory to hold both the old and the new images, it deletes
the old image. The image is always stored in a subdirectory on the flash memory. The subdirectory
name is the same as the image release name, for example cigesm-i6q2l2q4-tar.121-22.EA9.tar.
the old image. The image is always stored in a subdirectory on the flash memory. The subdirectory
name is the same as the image release name, for example cigesm-i6q2l2q4-tar.121-22.EA9.tar.
•
After the new image is downloaded, it automatically sets the BOOT environment variable. You do
not have to change the names of old file names to new file names.
not have to change the names of old file names to new file names.
•
If you enter the command with the /reload or the /force-reload option, it automatically reloads the
switch after the upgrade.
switch after the upgrade.
For more information on using these commands, see the command reference for this release.
Table 2
Cisco IOS Software Image Files for This Release
Filename
Description
cigesm-i6q4l2-tar.121-22.EA12.tar
Noncryptographic Cisco IOS 12.1(22)EA12 image and
device manager files
device manager files
cigesm-i6k2l2q4-tar.121-22.EA12.tar
Cryptographic Cisco IOS 12.1(22)EA12 image and device
manager files
manager files