Cisco Cisco Fiber IGESM Switch Module for IBM Release Notes

Use the BladeCenter Management Module web page to assign IP information to the switch. For more 
information, refer to the Cisco Systems Intelligent Gigabit Ethernet Switch Module for the IBM 
BladeCenter Installation Guide or the Cisco Systems Intelligent Gb Fiber Ethernet Switch Module for 
the IBM BladeCenter Installation Guide.

These sections describe the new supported hardware and the new software features provided in this 
release: 

For a complete list of supported hardware, see the 

There are no new software features in this release. 

You should review this section before you begin working with the switches. These are known limitations 
that will not be fixed, and there is not always a workaround. Some features might not work as 
documented, and some features could be affected by recent changes to the switch hardware or software.

These limitations and restrictions apply to all switches unless otherwise noted.

These sections describe the limitations and restrictions:

These limitations and restrictions apply to the Cisco IOS configuration:

Root guard is inconsistent when configured on a port that is in the STP blocked state at the time of 
configuration. (CSCdp85954)

Aging of dynamic addresses does not always occur exactly after the specified aging time elapses. It 
might take up to three times this time period before the entries are removed from the table. 
(CSCdr96565)