Cisco Cisco SCE 1010 Service Control Engine Installation Guide
37
Final Tests
The procedures for performing the final tests to verify that the SCE 1000 is functioning properly are explained in the following
sections.
sections.
•
•
Verifying Operational Status
After all the ports are connected, verify that the Cisco SCE 1000 is not in a Warning state.
To verify that the Cisco SCE 1000 is not in a warning state, complete the following steps:
Step 1
On the Cisco SCE 1000 Front panel, examine that the Status LED is flashing green.
Step 1
To display the operation status of the system, at the Cisco SCE 1000# prompt, type
show system operation-status
and press Enter.
A message displaying the operation status of the system appears. If the system is operating in order, the following
message appears:
message appears:
System Operation status is Operational.
Example:
The following example displays a sample output where the LEDs appear red/orange:
SCE 1000# show system operation-status
System Operation status is Operational
Viewing the User Log Counters
View the user log for errors that occurred during the installation process.
To display the user log device counters, complete the following steps:
Step 1
At the Cisco SCE 1000# prompt, type
show logger device User-File-Log counters
and press Enter.
Example:
The following example shows the current User-File-Log device counters.
SCE 1000# show logger device user-file-log counters
Logger device User-File-Log counters:
Total info messages: 1
Total warning messages: 0
Total error messages: 0
Total fatal messages: 0
If there are “Total error messages” or “Total fatal messages”, use the show logger device User-File-Log command to display
details about the errors.
details about the errors.