Cisco Cisco Customer Voice Portal 8.0(1)
Configuring the Gateway for IP to TDM Calls
The following components are required in order for the gateway to process IP to TDM calls:
•
Phones and numbers must be configured on the TDM switch.
•
Gateway must be defined on Unified CM.
•
Route pattern on Unified CM that will send the call to the gateway.
•
Need to configure a dial peer on the gateway that sends calls.
•
Dial 888800605x on the IP phone (this is a specific physical phone extension).
Step 1
Configure the gateway to send the call to a particular VXML Server application, as follows:
dial-peer voice 8888 voip
service [gateway application name]
incoming called-number 888800....
dtmf-relay rtp-nte h245-signal h245-alphanumeric
codec g711ulaw
no vad
Step 2
To match the number in the VXML Server transfer node and send it out the T1 port to the G3
to its destination, use the following configuration:
to its destination, use the following configuration:
dial-peer voice 8880 pots
destination-pattern 888800....
incoming called-number
direct-inward-dial
port 1/0:D
Configuring a Cisco Multiservice IP-to-IP Gateway for Unified CM Connections
Unified CM IP- to-IP calls that are routed through an H.323 endpoint or H.323 gateway, you
must configure the following:
must configure the following:
Step 1
Configure the IPIPGW to transport calls to and from Unified CM.
Configuration and Administration Guide for Cisco Unified Customer Voice Portal Release 4.1(1)
307
Chapter 7: Configuring VXML Solution
Passing Data to Unified ICME