Cisco Cisco Application Extension Platform for SRE
Cisco Application eXtension Platform 1.0 Quick Start Guide
Configuring the Cisco AXP Service Module
5
Cisco Application eXtension Platform 1.0 Quick Start Guide
OL-15669-01
duplex full
speed auto
no mop enabled
!
interface Integrated-Service-Engine 1/0
shutdown
no keepalive
no mop enabled
!
!
Tip
Press the space bar to scroll through the output if the entire configuration is not visible on your screen.
The running configuration shows multiple interfaces, for example: FastEthernet0/0 (FE0/0),
FastEthernet0/1 (FE0/1), and Integrated-Service-Engine1/0 (ISE1/0). The number of interfaces on your
Cisco 280x ISR depends on the model and number of service modules that are installed. See
FastEthernet0/1 (FE0/1), and Integrated-Service-Engine1/0 (ISE1/0). The number of interfaces on your
Cisco 280x ISR depends on the model and number of service modules that are installed. See
for links to hardware documentation.
Step 3
Use the show interfaces command to view all the interfaces, or use the command with keywords to view
specific interfaces:
specific interfaces:
2800_w_axp# show interfaces FastEthernet 0/0
2800_w_axp# show interfaces FastEthernet 0/1
2800_w_axp# show interfaces Integrated-Service-Engine 1/0
Tip
Press the space bar repeatedly to scroll through the output.
Configuring the Cisco AXP Service Module
This section consists of:
•
•
Cisco AXP Command Modes
The Cisco AXP command environment on the service module consists of the command modes shown in
.
Table 3
Cisco AXP Command Modes
Mode
Example
Cisco AXP application service configuration mode
se-Module(config)> app-service helloworld
se-Module(config-helloworld)>
Cisco AXP application service EXEC mode
se-Module> app-service application-name
Example:
se-Module> app-service helloworld
se-Module(exec-helloworld)>