Cisco Cisco Application Extension Platform for SRE

To exit the Cisco AXP command environment and return to the Cisco 280x ISR command environment: 
1. Return to Cisco AXP EXEC mode, and 
2. Type exit. 
For example:

se-Module> exit

2800__axp#

Configure the Integrated Service Engine interface from the Cisco 280x ISR, using the Cisco IOS CLI. 

The ISE1/0 port connects the ISE1/0 service module to the router. The ISE1/0 port is internal and you 
cannot physically see it by looking at the Cisco 280x ISR. (In the examples in this document, the service 
module is “se-Module”, see examples in 

In order to gain IP connectivity to the Cisco AXP service module, you must first configure IP parameters 
from the Cisco 280x ISR. You must also give the Cisco AXP service module a default gateway that it 
can use to ensure full connectivity of your application. 

To configure the Cisco AXP Service Module, perform the following steps:

Enter configuration mode, by entering the following command:

2800_w_axp# configure terminal <enter>

2800_w_axp(config)# 

You can now make changes to the current running configuration file. For a complete running 
configuration used in the examples in this guide, see the 

.

To configure the ISE1/0 interface, enter the configuration context for the interface, by typing the 
following command:

2800_w_axp(config)# interface Integrated-Service-Engine 1/0 <enter>

2800_w_axp(config-if)#

Check for basic IP connectivity by entering the following three commands.

Cisco AXP configuration mode

se-Module> config t 

se-Module(config)> 

Cisco AXP EXEC mode

1

se-Module> 

1.

This mode is similar to the Cisco IOS privileged EXEC mode.