Cisco Cisco CRS-X Multishelf System Installation Guide
When installing or moving the chassis, the required service access area in front of the chassis may be more
than the minimum of 36 inches (91.4 cm) specified in the figure below, depending on what type of lifting
device is used.For chassis installation, make sure that enough room exists in front of the chassis to
accommodate installation personnel and the scissor lift (or other lifting device) used to hold the chassis
in the rack while it is bolted to the rack.
than the minimum of 36 inches (91.4 cm) specified in the figure below, depending on what type of lifting
device is used.For chassis installation, make sure that enough room exists in front of the chassis to
accommodate installation personnel and the scissor lift (or other lifting device) used to hold the chassis
in the rack while it is bolted to the rack.
Note
Figure 3: Typical Cisco CRS 4-Slot Line Card Chassis Floor Plan
Moving the Chassis to the Installation Site
This section describes how to move the unpacked LCC. The LCC is shipped with the front vertical mounting brackets preinstalled
for attaching the chassis to the rack. For stability and support, you must leave the mounting brackets installed when you move the
chassis.
for attaching the chassis to the rack. For stability and support, you must leave the mounting brackets installed when you move the
chassis.
The chassis is shipped with impedance carriers installed over all slots. We recommend leaving these in
place to maintain chassis stiffness and integrity during moving.
place to maintain chassis stiffness and integrity during moving.
Note
14