Intel QX6700 HH80562PH0678M User Manual

28

Datasheet

.

1.

Unless otherwise noted, all specifications in this table apply to all processor frequencies.

V

L

Input Low Voltage

-0.30

N/A

N/A

V

2

2.

"Steady state" voltage, not including overshoot or undershoot.

V

H

Input High Voltage

N/A

N/A

1.15

V

V

CROSS(abs)

Absolute Crossing Point

0.300

N/A

0.550

V

3, 4, 5

3.

Crossing voltage is defined as the instantaneous voltage value when the rising edge of BCLK0

equals the falling edge of BCLK1. 

4.

The crossing point must meet the absolute and relative crossing point specifications

simultaneously

5.

V

Havg

 is the statistical average of the V

H

 measured by the oscilloscope.

 ΔV

CROSS

Range of Crossing Points

N/A

N/A

0.140

V

-

V

OS

Overshoot

N/A

N/A

1.4

V

6

6.

Overshoot is defined as the absolute value of the maximum voltage. Undershoot is defined as

the absolute value of the minimum voltage.

V

US

Undershoot

-0.300 N/A

N/A

V

V

SWING

Differential Output Swing

0.300

N/A

N/A

V

7

7.

Measurement taken from differential waveform.

1.

Unless otherwise noted, all specifications in this table apply to all processor core frequencies

based on a 266 MHz BCLK[1:0].

BCLK[1:0] Frequency

265.307

—

266.746

MHz

2

2.

Duty Cycle (High time/Period) must be between 40 and 60%.

T1: BCLK[1:0] Period

3.74963

—

3.76922

ns

3

3.

The period specified here is the average period. A given period may vary from this specification

as governed by the period stability specification (T2). Min period specification is based on 

-300 PPM deviation from a 3.75 ns period. Max period specification is based on the summation

of +300 PPM deviation from a 3.75 ns period and a +0.5% maximum variance due to spread

spectrum clocking.

T2: BCLK[1:0] Period Stability

—

—

150

ps

4

4.

In this context, period stability is defined as the worst case timing difference between successive

crossover voltages. In other words, the largest absolute difference between adjacent clock

periods must be less than the period stability.

T5:  BCLK[1:0] Rise and Fall Slew 

Rate

2.5

—

8

V/nS

5

5.

Measurement taken from differential waveform.

T6: Slew Rate Matching

N/A

N/A

20

%

6

6.

Matching applies to rising edge rate for Clock and falling edge rate for Clock#. It is measured

using a ±75 mV window centered on the average cross point where Clock rising meets Clock#

falling. The median cross point is used to calculate the voltage thresholds the oscilloscope is to

use for the edge rate calculations.