Cisco Cisco ASR 5700
APN Configuration Mode Commands
timeout bearer-inactivity ▀
Command Line Interface Reference, StarOS Release 17 ▄
1451
gbr
Specifies that the GGSN/GW will check for low activity on a GBR bearer.
non-gbr
Specifies that the GGSN/GW will check for low activity on a non-GBR bearer.
Important:
P-GW only supports non-GBR bearer type sessions.
dur_seconds
Specifies the timeout duration in seconds to check inactivity on the bearer.
In StarOS 16.0 and later releases:
In StarOS 16.0 and later releases:
dur_seconds
must be an integer value from 300 to 2592000 (5 minutes to 720 hours). The minimum
configurable value of bearer inactivity timer was reduced from 900 seconds to 300 seconds.
In StarOS 15.0 releases:
In StarOS 15.0 releases:
dur_seconds
must be an integer value from 900 to 2592000 (15 minutes to 720 hours). The minimum
configurable value of bearer inactivity timer was reduced from 3600 seconds to 900 seconds.
In StarOS 14.x and earlier releases:
In StarOS 14.x and earlier releases:
dur_seconds
must be an integer value from 3600 through 2592000.
volume-threshold
This keyword sets the volume threshold in bytes to check the low activity on the bearer.
downlink
Threshold value of the downlink data traffic in a bearer.
total
Specifies that the total of both uplink and downlink data will be used as a volume threshold.
uplink
Threshold value of the uplink data traffic in a bearer.
bytes
bytes
must be an integer value from 1 through 4294967295.
del-cause { none | reactiv-req }
When subscribers are deleted due to APN timeouts, the GGSN/P-GW/SAEGW may include “Cause-IE” in
the resulting Delete Bearer/Delete PDP Context Requests generated for default bearer.
the resulting Delete Bearer/Delete PDP Context Requests generated for default bearer.
none
: Omit GTP “Cause-IE” in DBR/DPC when timeout occurs on default bearer.
reactiv-req
: The DBR/DPC will include “Cause-IE” with GTP cause code “Reactivation Requested”.
This behavior is applicable only if Delete Bearer Request is sent for default bearer, or Delete PDP Context is
sent to delete the PDN connection or its last PDP context.
The behavior for “Cause-IE” specified in this CLI shall override the cause-code set by existing features.
By default, the
sent to delete the PDN connection or its last PDP context.
The behavior for “Cause-IE” specified in this CLI shall override the cause-code set by existing features.
By default, the
del-cause
option is not defined and existing behavior is retained.