Cisco Cisco ASR 5700
APN Profile Configuration Mode
▀ virtual-mac
▄ Command Line Interface Reference, StarOS Release 17
1556
virtual-mac
Configures the virtual MAC address for this APN profile to use as the default gateway’s MAC address for the user
equipment (UE). This command is specific to SaMOG.
equipment (UE). This command is specific to SaMOG.
Product
SaMOG
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > APN Profile Configuration
configure > apn-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(apn-profile-profile_name)#
Syntax
[ no ] virtual-mac mac_address
no
Removes the virtual MAC configuration from this APN profile.
mac_address
Specifies the media-specific access control layer address.
mac_address
must be specified as a 6-byte
hexadecimal number with each byte separated by a colon or hyphen, for example., “AA:12:bb:34:f5:0E” or
“AA-12-bb-34-f5-0E”.
“AA-12-bb-34-f5-0E”.
Usage
Use this command to configure the virtual MAC address for this APN profile to use as the default gateway’s
MAC address for the user equipment (UE).
By default, virtual MAC is not configured. In the event where no virtual MAC is configured, SaMOG creates
a virtual MAC by adding fe:ff to the start of the IPv4 bind address of the CGW service.
MAC address for the user equipment (UE).
By default, virtual MAC is not configured. In the event where no virtual MAC is configured, SaMOG creates
a virtual MAC by adding fe:ff to the start of the IPv4 bind address of the CGW service.
Important:
Dynamic change in the virtual MAC address will only affect new sessions. Older sessions will
continue to use the old virtual MAC address until the session exists.
Example
The following command configures a virtual mac with the IP address of AB:12:22:34:f5:0E for this APN
profile:
profile:
virtual-mac AB:12:22:34:f5:0E