Cisco Cisco ASR 5700
ATM Port Configuration Mode Commands
threshold monitoring ▀
Command Line Interface Reference, StarOS Release 17 ▄
1591
threshold monitoring
Enables thresholding for port-level values.
Product
HNB-GW
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > ATM Port Configuration
configure > port atm slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
[ default | no ] threshold monitoring
default
Restores the system default to disable threshold monitoring for port-level values.
no
Disables threshold monitoring for port-level values. This is the default setting.
Usage
Thresholding on the system is used to monitor the system for conditions that could potentially cause errors or
outage. Typically, these conditions are temporary (i.e high-activity) and are quickly resolved. However,
continuous or large numbers of these error conditions within a specific time interval may be indicative of
larger, more severe issues. The purpose of thresholding is to help identify potentially severe conditions so that
immediate action can be taken to minimize and/or avoid system downtime.
Thresholding reports conditions using one of the following mechanisms:
outage. Typically, these conditions are temporary (i.e high-activity) and are quickly resolved. However,
continuous or large numbers of these error conditions within a specific time interval may be indicative of
larger, more severe issues. The purpose of thresholding is to help identify potentially severe conditions so that
immediate action can be taken to minimize and/or avoid system downtime.
Thresholding reports conditions using one of the following mechanisms:
SNMP traps: SNMP traps have been created that indicate the condition (high threshold crossing and/or
clear) of each of the monitored values. Complete descriptions and other information pertaining to
these traps is located in the starentMIB(8164).starentTraps(2) section of the SNMP MIB Reference.
these traps is located in the starentMIB(8164).starentTraps(2) section of the SNMP MIB Reference.
The generation of specific traps can be enabled or disabled on the system allowing you to view only those
traps that are most important to you.
traps that are most important to you.
Logs: The system provides a facility called threshold for which active and event logs can be generated.
As with other system facilities, logs are generated Log messages pertaining to the condition of a
monitored value are generated with a severity level of WARNING.
monitored value are generated with a severity level of WARNING.
Alarm System: High threshold alarms generated within the specified polling interval are considered
“outstanding” until a the condition no longer exists and/or a condition clear alarm is generated.
“Outstanding” alarms are reported to through the system’s alarm subsystem and are viewable through the
system’s CLI.
The following table indicates the reporting mechanisms supported by each of the above models.
system’s CLI.
The following table indicates the reporting mechanisms supported by each of the above models.