Cisco Cisco ASR 5700
Context Configuration Mode Commands E-H
▀ gtpp attribute
▄ Command Line Interface Reference, StarOS Release 17
2432
apn-ni
Default: Enabled
This keyword controls the inclusion of the optional field “APN” in the x-CDRs.
This keyword controls the inclusion of the optional field “APN” in the x-CDRs.
apn-selection-mode
Default: Enabled
This keyword controls the inclusion of the optional field “APN Selection Mode” in the x-CDRs.
This keyword controls the inclusion of the optional field “APN Selection Mode” in the x-CDRs.
camel-info
SGSN only
Enter this keyword to include CAMEL-specific fields in SGSN CDRs. Default: Disabled
Enter this keyword to include CAMEL-specific fields in SGSN CDRs. Default: Disabled
cell-plmn-id
SGSN only
Enter this keyword to enable the system to include the Cell PLMN ID field in the M-CDR. Default: Disabled
Enter this keyword to enable the system to include the Cell PLMN ID field in the M-CDR. Default: Disabled
charging-characteristic-selection-mode
Default: Enabled
This keyword controls the inclusion of the optional field “Charging Characteristic Selection Mode” in the x-
CDRs.
This keyword controls the inclusion of the optional field “Charging Characteristic Selection Mode” in the x-
CDRs.
diagnostics
Default: Disabled
Enables the system to include the Diagnostic field in the CDR that is created when PDP contexts are released.
The field will include one of the following values:
Enables the system to include the Diagnostic field in the CDR that is created when PDP contexts are released.
The field will include one of the following values:
26 - For GGSN: if the GGSN sends “delete PDP context request” for any other reason (e.g., the
operator types “clear subscribers” on the GGSN). For SGSN: The SGSN includes this cause code in
the S-CDR to indicate that a secondary PDP context activation request or a PDP context
modification request has been rejected due to insufficient resources.
the S-CDR to indicate that a secondary PDP context activation request or a PDP context
modification request has been rejected due to insufficient resources.
36 - For GGSN: this cause code is sent in the G-CDR to indicate the PDP context has been deactivated
in the GGSN due to the SGSN having sent a “delete PDP context request” to the GGSN. For SGSN,
this cause code is used to indicate a regular MS or network-initiated PDP context deactivation.
this cause code is used to indicate a regular MS or network-initiated PDP context deactivation.
37 - when the network initiates a QoS modification, the SGSN sends in the S-CDR to indicate that the
MS initiation deactivate request message has been rejected with QoS not accepted as the cause.
38 - if the GGSN sends “delete PDP context request” due to GTP-C/GTP-U echo timeout with SGSN.
If the SGSN sends this cause code, it indicates PDP context has been deactivated due to path failure,
specifically GTP-C/GTP-U echo timeout.
specifically GTP-C/GTP-U echo timeout.
39 - SGSN only - this code indicates the network (GGSN) has requested a PDP context reactivation
after a GGSN restart.
40 - if the GGSN sends “delete PDP context request” due to receiving a RADIUS Disconnect-Request
message.
direct-tunnel
Default: Disabled
Includes the Direct Tunnel field in PGW-CDR/eG-CDRs.
This keyword is applicable for GGSN, P-GW and S-GW only.
Includes the Direct Tunnel field in PGW-CDR/eG-CDRs.
This keyword is applicable for GGSN, P-GW and S-GW only.