Cisco Cisco ASR 5700
Diameter Host Select Configuration Mode Commands
▀ host-select table
▄ Command Line Interface Reference, StarOS Release 17
3558
Specifies the Diameter host table that will be edited.
1: Specifies the primary table
2: Specifies the secondary table
prefix-table { 1 | 2 }: Specifies a primary or secondary table containing ranges of MSISDN prefixes.
This keyword option enables activating the configured table.
table { 1 | 2 | range-table { 1 | 2 } }
Important:
This command syntax is applicable to StarOS release 15.0 and later.
Specifies the Diameter host table that will be edited.
1: Specifies the primary table
2: Specifies the secondary table
range-table { 1 | 2 }: Specifies a primary or secondary table containing ranges of IMSI or MSISDN
prefix/suffix.
This keyword option enables activating the configured table.
algorithm { ip-address-modulus [ prefer-ipv4 | prefer-ipv6 ] | msisdn-modulus |
round-robin }
round-robin }
Specifies the algorithm to be used when selecting a row in this table.
ip-address-modulus: Use an IP address (in binary) to select a row.
prefer-ipv4: If both IPv4 and IPv6 addresses are available, use the IPv4 address.
prefer-ipv6: If both IPv4 and IPv6 addresses are available, use the IPv6 address.
msisdn-modulus: Use an MSISDN (without leading “+”) to select a row.
round-robin: Select a row in round-robin manner for each new session.
Important:
The Round Robin algorithm is effective only over a large number of selections, and not at a granular
level.
Usage
Use this command to add or modify a Diameter host server table associated with a Diameter host template.
Example
The following command adds a primary table that uses the ip-address-modulus algorithm for selecting a row:
host-select table 1 algorithm ip-address-modulus