Cisco Cisco ASR 5700
ACS Charging Action Configuration Mode Commands
▀ ip tos
▄ Command Line Interface Reference, StarOS Release 17
416
downlink
Specifies the ToS only for downlink packets.
uplink
Specifies the ToS only for uplink packets.
Usage
Use this command to specify the IP Type of Service (ToS) octets to use in the charging action. If one of the
enumerated values is set, the DSCP bits which are the six most-significant bits in the TOS byte are marked. If
the integer value is set, it will be written into the six least-significant bits of the TOS byte.
If
enumerated values is set, the DSCP bits which are the six most-significant bits in the TOS byte are marked. If
the integer value is set, it will be written into the six least-significant bits of the TOS byte.
If
downlink
or
uplink
keywords are not specified, the command applies to both directions.
This command may be used multiple times. For example, the following sequence of commands will cause to
set the ToS to af11 in the uplink direction, but not modify the ToS in the downlink direction:
set the ToS to af11 in the uplink direction, but not modify the ToS in the downlink direction:
ip tos af11
no ip tos downlink
Example
The following command sets the IP ToS to
be
with
downlink
:
ip tos be downlink