Cisco Cisco ASR 5700
Exec Mode Commands (T-Z)
update active-charging ▀
Command Line Interface Reference, StarOS Release 17 ▄
4221
Important:
It is recommended that this CLI command is executed after all rulebase/charging action/ruledef
changes are complete. So, this will help in one-time execution of the CLI to get all PDN sessions in sync.
Typically, this command is used whenever any rulebase, charging action or ruledef modification happens.
Once this CLI command is executed, each subscriber will read the configuration and incorporate the rulebase
or ruledef changes for Override Control. Until this CLI execution is complete, Inheritance or Override
Control values will not be applied to the changes done in configuration for all existing calls. Charging and
policy parameters configured at P-GW will apply during this period. Please follow recommended upgrade
procedures to avoid this. For the upgrade procedure, contact your Cisco account representative.
In release 17, the batch processing will complete in 15 to 20 minutes depending on the call load in the system.
If the
Once this CLI command is executed, each subscriber will read the configuration and incorporate the rulebase
or ruledef changes for Override Control. Until this CLI execution is complete, Inheritance or Override
Control values will not be applied to the changes done in configuration for all existing calls. Charging and
policy parameters configured at P-GW will apply during this period. Please follow recommended upgrade
procedures to avoid this. For the upgrade procedure, contact your Cisco account representative.
In release 17, the batch processing will complete in 15 to 20 minutes depending on the call load in the system.
If the
override-control rulebase-config
command has been issued multiple times, batch processing
will be restarted and the latest rulebase/charging action/ruledef changes will be applied to all the active calls.
Important:
In release 17, there was no restriction on the usage of the CLI command “
update active-
charging override-control rulebase-config
” on a standby chassis. In release 18 and later, this CLI command
is not allowed to be executed on the standby chassis.
switch-to-fw-and-nat-policy
fw_nat_policy_name
Specifies an existing Firewall-and-NAT policy to switch to as an alphanumeric string of 1 through 63
characters.
characters.
switch-to-rulebase
rulebase_name
Specifies an existing rulebase to switch to as an alphanumeric string of 1 through 63 characters.
all
Updates rulebase/policy for all subscribers.
callid call_id
Updates rulebase/policy for the Call Identification number specified as an eight-digit hexadecimal number.
fw-and-nat-policy
fw_nat_policy_name
Updates the rulebase/policy for sessions matching an existing Firewall-and-NAT policy specified as an
alphanumeric string of 1 through 63 characters.
alphanumeric string of 1 through 63 characters.
imsi imsi
Updates rulebase/policy for International Mobile Subscriber Identification (IMSI) specified here.
imsi
must be 3 digits of MCC (Mobile Country Code), 2 or 3 digits of MNC (Mobile Network Code), and
the rest with MSIN (Mobile Subscriber Identification Number). The total should not exceed 15 digits. For
example, 123-45-678910234 can be entered as 12345678910234.
example, 123-45-678910234 can be entered as 12345678910234.
ip-address iP_address
Updates rulebase/policy for the IP address specified in IPv4 dotted-decimal or IPv6 colon-separated-
hexadecimal notation.
hexadecimal notation.
msid msid
Updates rulebase/policy for an MSID specified as a string of 1 through 24 characters.