Cisco Cisco ASR 5700
PCC-Service-Profile Configuration Mode Commands
eval-priority ▀
Command Line Interface Reference, StarOS Release 17 ▄
7691
condition-group
cond_grp_name
Specifies a pre-configured PCC-Condition-Group to be set for evaluation priority in a PCC-Service-Profile
instance.
instance.
cond_grp_name
is a pre-configured PCC-Condition-Group and must be an alphanumerical string of 1
through 63 characters.
Important:
An special PCC-Condition-Group “none” can be used to set the default PCC-Condition-Group for
any-match typically used for a default condition for a session which does not match any of the conditions specified
with higher evaluation priority.
with higher evaluation priority.
action-set
actionset_name
Specifies a pre-configured PCC-Action-Set for PCC-Condition-Group to be set for evaluation priority in a
PCC-Service-Profile instance.
PCC-Service-Profile instance.
actionset_name
is a pre-configured PCC-Action-Set and must be an alphanumerical string of 1 through 63
characters.
Usage
Use this command to set the priority for evaluation of PCC-Condition-Group with corresponding PCC-
Action-Set in a PCC-Service-Profile which is to use in Subscriber profile in PCC-Service instance on IPCF
node.
Additionally
Action-Set in a PCC-Service-Profile which is to use in Subscriber profile in PCC-Service instance on IPCF
node.
Additionally
timedef
is used to accept the Timedefs to support the time-of-day-based procedures to trigger
an evaluation priority. The action is triggered only when the time of session lies in the time span defined in
specific PCC-Timedef
specific PCC-Timedef
timedef_name
.
Default eval-priority has the lowest priority in the PCC-Service-Profile and as default eval-priority does not
have any PCC-Condition-Group associated with it, all the actions in the action-set always be applied.
A maximum of 64 PCC-Evaluation-Priorities can be configured in a PCC-Service-Profile.
have any PCC-Condition-Group associated with it, all the actions in the action-set always be applied.
A maximum of 64 PCC-Evaluation-Priorities can be configured in a PCC-Service-Profile.
Example
Following command sets the evaluation priority value as
1
for PCC-Condition-Group
cond_1
along with
PCC-Action-Set
act_cond1
for PCC-Service-Profile instance on IPCF node:
eval-priority 1 condition-group cond_1 action-set act_cond1
Following command sets the evaluation priority value as
2
for PCC-Condition-Group
none
for any-match
typically used for a default condition for a session which does not match any of the conditions specified with
higher evaluation priority.along with PCC-Action-Set
higher evaluation priority.along with PCC-Action-Set
act_cond1
for PCC-Service-Profile instance on IPCF
node:
eval-priority 1 condition-group none action-set act_cond1