Cisco Cisco ASR 5700
WSG Service Configuration Mode Commands
▀ initiator-mode-duration
▄ Command Line Interface Reference, StarOS Release 17
8986
initiator-mode-duration
Specifies the interval during which the WSG service (SecGW) will try to initiate a call with an IKE peer. A peer list
must be configured in this WSG service for this command to be available (VPC only).
must be configured in this WSG service for this command to be available (VPC only).
Product
SecGW (WSG)
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > WSG-Service Configuration
configure > context context_name > wsg-service
service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-wsg-service)#
Syntax
initiator-mode-duration seconds
default initiator-mode-duration
default
Sets the initiator mode duration to 10 seconds.
seconds
Specifies the duration interval in seconds as an integer from 5 through 250.
Usage
Use this command to specify the interval during which the WSG service (SecGW) will try to initiate an IKE
call when a peer list is activated (default is 10 seconds).
This command is only available when a peer-list has been configured for the WSG service.
See the IPSec Reference for additional information on configuring an SecGW as an IKE initiator.
call when a peer list is activated (default is 10 seconds).
This command is only available when a peer-list has been configured for the WSG service.
See the IPSec Reference for additional information on configuring an SecGW as an IKE initiator.
Example
The following command sets the initiator mode duration to 15 seconds:
initiator-mode-duration 15