Cisco Cisco ASR 5700
ACS Ruledef Configuration Mode Commands
multi-line-or all-lines ▀
Command Line Interface Reference, StarOS Release 17 ▄
997
multi-line-or all-lines
This command applies the OR operator to all lines in the current ruledef.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] multi-line-or all-lines
no
If previously configured, deletes this configuration in the current ruledef.
multi-line-or all-lines
Applies the OR operator to all lines in the current ruledef.
Usage
When a ruledef is evaluated, if the
multi-line-or all-lines
command is configured, the logical OR
operator is applied to all the rule expressions in the ruledef to decide if the ruledef matches or not. If the
multi-line-or all-lines
command is not configured, the logical AND operator is applied to all the rule
expressions.
The intent of this command is to allow a single ruledef to specify multiple URL expressions. Otherwise,
multiple ruledefs need to be created, each with one URL expression. When this CLI command is used, each
expression in the ruledef impacts the total number of ruledefs allowed. So from a “maximum number of
possible ruledefs” perspective, it makes no difference whether there are N ruledefs with one expression each,
or one ruledef with N expressions.
The intent of this command is to allow a single ruledef to specify multiple URL expressions. Otherwise,
multiple ruledefs need to be created, each with one URL expression. When this CLI command is used, each
expression in the ruledef impacts the total number of ruledefs allowed. So from a “maximum number of
possible ruledefs” perspective, it makes no difference whether there are N ruledefs with one expression each,
or one ruledef with N expressions.