Cisco Cisco ASR 5700
APN Configuration Mode Commands
ipv6 access-group ▀
Command Line Interface Reference, StarOS Release 17 ▄
1375
ipv6 access-group
Configures the IPv6 access group for the current APN profile which applies a single Access Control List (ACL) to
multiple subscribers via the APN for IPv6 traffic.
multiple subscribers via the APN for IPv6 traffic.
Product
GGSN
ACS
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-apn)#
Syntax
ipv6 access-group group_name [ in | out ] [ fallback-enabled ]
[ no ] ipv6 access-group group_name [ in | out ]
no
Removes a previously configured IPv6 ACL applied to a particular APN for IPv6 traffic. If at least one of the
two
two
{ in | out }
options is not selected for the ACL that will be removed, the ACL will be removed for
both directions.
group_name
Specifies the name of the IPv6 access group as an alphanumeric string of 1 through 79 characters.
in | out
Default: both (in and out)
Specifies the access-group as either inbound or outbound by the keywords
Specifies the access-group as either inbound or outbound by the keywords
in
and
out
, respectively.
If no direction is supplied in the base command, the specified IPv6 access control list will be applied to both
directions.
directions.
fallback-enabled
When invalid ACL is received from RADIUS during Context Activation, ACL in this APN will be applied so
there is no loss of CDR or missing charging information.
By default, ACL fallback is disabled.
there is no loss of CDR or missing charging information.
By default, ACL fallback is disabled.