Cisco Cisco ASR 5700
ACS Rulebase Configuration Mode Commands
▀ flow rtsp-all-pkts
▄ Command Line Interface Reference, StarOS Release 17
728
flow rtsp-all-pkts
This command allows you to delay charge packets in an RTSP flow.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
[ no | default ] flow rtsp-all-pkts charge-to-application
no
If previously configured, deletes the flow rtsp-all-pkts configuration from the current rulebase.
default
Configures this command with its default setting.
Default: Same as
Default: Same as
no flow rtsp-all-pkts charge-to-application
.
flow rtsp-all-pkts charge-to-application
Configures delay charging for RTSP traffic. When this configuration is enabled, all packets (TCP control
packets and RTSP packets) prior to the RTSP SETUP will be charged to application as per the application
ruledef. In other words, they will be charged to the content-id established by the first SETUP of the RTSP
flow.
packets and RTSP packets) prior to the RTSP SETUP will be charged to application as per the application
ruledef. In other words, they will be charged to the content-id established by the first SETUP of the RTSP
flow.
Usage
Use this command to delay charge packets in a RTSP flow. All initial packets (TCP control packets (all
packets including initial, mid-session, end-session) and RTSP packets prior to the first SETUP) can be delay
charged. Apart from the initial packets, all intermittent TCP control packets are also charged to the last
matched Ruledef for the given RTSP flow. This command is used in conjunction with the
packets including initial, mid-session, end-session) and RTSP packets prior to the first SETUP) can be delay
charged. Apart from the initial packets, all intermittent TCP control packets are also charged to the last
matched Ruledef for the given RTSP flow. This command is used in conjunction with the
rtsp initial-
bytes-limit RTSP_bytes
command.
The following command enables the RTSP flow’s delay charging:
flow rtsp-all-pkts charge-to-application