Cisco Cisco ASR 5000
There are additional configuration parameters that are not described in this section. These parameters deal
mostly with fine-tuning the operation of the HSGW in the network. Information on these parameters can be
found in the appropriate sections of the Command Line Interface Reference.
mostly with fine-tuning the operation of the HSGW in the network. Information on these parameters can be
found in the appropriate sections of the Command Line Interface Reference.
Required Local Context Configuration Information
The following table lists the information that is required to configure the local context on an HSGW.
Description
Required Information
Management Interface Configuration
An identification string between 1 and 79 characters (alpha and/or numeric)
by which the interface will be recognized by the system.Multiple names
are needed if multiple interfaces will be configured.
by which the interface will be recognized by the system.Multiple names
are needed if multiple interfaces will be configured.
Interface name
IPv4 addresses assigned to the interface.Multiple addresses and subnets
are needed if multiple interfaces will be configured.
are needed if multiple interfaces will be configured.
IP address and subnet
The physical port to which the interface will be bound. Ports are identified
by the chassis slot number where the line card resides followed by the
number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.A single physical port
can facilitate multiple interfaces.
by the chassis slot number where the line card resides followed by the
number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.A single physical port
can facilitate multiple interfaces.
Physical port number
Used when configuring static IP routes from the management interface(s)
to a specific network.
to a specific network.
Gateway IP address
The name or names of the security administrator with full rights to the
system.
system.
Security administrator name
Open or encrypted passwords can be used.
Security administrator password
The type of remote access that will be used to access the system such as
telnetd, sshd, and/or ftpd.
telnetd, sshd, and/or ftpd.
Remote access type(s)
Required HSGW Context Configuration Information
The following table lists the information that is required to configure the HSGW context on an HSGW.
Description
Required Information
An identification string from 1 to 79 characters (alpha and/or numeric) by
which the HSGW context is recognized by the system.
which the HSGW context is recognized by the system.
HSGW context name
The name of the Diameter dictionary used for authentication.
Diameter authentication
dictionary
dictionary
An identification string from 1 to 63 characters (alpha and/or numeric) by
which the Diameter endpoint is recognized by the system.The Diameter
endpoint name identifies the configuration used to communicate with the
3GPP AAA server in the AAA context.
which the Diameter endpoint is recognized by the system.The Diameter
endpoint name identifies the configuration used to communicate with the
3GPP AAA server in the AAA context.
Diameter endpoint name
HSGW Administration Guide, StarOS Release 19
38
HSGW Configuration
Information Required