Cisco Cisco ASR 5000
Description
Required Information
An identification string from 1 to 63 characters (alpha and/or numeric) by
which the accounting policy is recognized by the system. The accounting
policy is used to set parameters for the Rf (off-line charging) interface.
which the accounting policy is recognized by the system. The accounting
policy is used to set parameters for the Rf (off-line charging) interface.
Accounting policy name
A10/A11 Interface Configuration (To/from eAN/ePCF)
An identification string between 1 and 79 characters (alpha and/or numeric)
by which the interface is recognized by the system.Multiple names are
needed if multiple interfaces will be configured.
by which the interface is recognized by the system.Multiple names are
needed if multiple interfaces will be configured.
Interface name
IPv4 addresses assigned to the interface.Multiple addresses and subnets
are needed if multiple interfaces will be configured.
are needed if multiple interfaces will be configured.
IP address and subnet
The physical port to which the interface will be bound. Ports are identified
by the chassis slot number where the line card resides followed by the
number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.A single physical port
can facilitate multiple interfaces.
by the chassis slot number where the line card resides followed by the
number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.A single physical port
can facilitate multiple interfaces.
Physical port number
Used when configuring static IP routes from the management interface(s)
to a specific network.
to a specific network.
Gateway IP address
HSGW Service Configuration
An identification string from 1 to 63 characters (alpha and/or numeric) by
which the HSGW service is recognized by the system.Multiple names are
needed if multiple HSGW services will be used.
which the HSGW service is recognized by the system.Multiple names are
needed if multiple HSGW services will be used.
HSGW service name
eAN/ePCF IP address:Specifies the IP address of the eAN/ePCF. The
HSGW service allows the creation of a security profile associated with a
particular eAN/ePCF.
HSGW service allows the creation of a security profile associated with a
particular eAN/ePCF.
Security Parameter Index
Remote Address
Remote Address
SPI number:Specifies the SPI (number) which indicates a security context
between the eAN/ePCF and the HSGW.
between the eAN/ePCF and the HSGW.
Encrypted secret:Configures the shared-secret between the HSGW service
and the eAN/ePCF. This command can also be non-encrypted.
and the eAN/ePCF. This command can also be non-encrypted.
Required MAG Context Configuration Information
The following table lists the information that is required to configure the MAG context on an HSGW.
Description
Required Information
An identification string from 1 to 79 characters (alpha and/or numeric) by
which the MAG context is recognized by the system.
which the MAG context is recognized by the system.
MAG context name
S2a Interface Configuration (To/from P-GW LMA)
An identification string between 1 and 79 characters (alpha and/or numeric)
by which the interface is recognized by the system.Multiple names are
needed if multiple interfaces will be configured.
by which the interface is recognized by the system.Multiple names are
needed if multiple interfaces will be configured.
Interface name
HSGW Administration Guide, StarOS Release 19
39
HSGW Configuration
Information Required