Cisco Cisco Broadband Access Center Telco Wireless 3.8
C-19
Cisco Broadband Access Center for Cable Administrator’s Guide
OL-2445-02
Appendix C Device Provisioning Engine Command Line Interface
Support and Troubleshooting Commands
Examples
This is an example of how to use the tftp verify-ip command:
dpe# tftp verify-ip
%OK
uptime
Usage Guidelines
This command identifies how long the system has been operational. This information is useful when
determining how frequently the device is rebooted. It is also helpful when checking the reliability of the
DPE when it is in a stable condition.
determining how frequently the device is rebooted. It is also helpful when checking the reliability of the
DPE when it is in a stable condition.
Examples
This is an example of how to use the uptime command:
dpe# uptime
11:54am up 2:07, 1 users, load average: 0.27, 0.08, 0.02
Support and Troubleshooting Commands
This section describes those CLI commands that assist in supporting and troubleshooting the operation
of the DPE. These CLI commands include:
of the DPE. These CLI commands include:
•
•
•
•
•
•
•
•
•
•
clear bundles
Usage Guidelines
This command clears any existing archived bundles on the DPE. These bundles are created using the
support bundles commands and normally contain archived logs and archived state information of use
to the Cisco TAC. You must ensure that all bundles are retrieved before using this command because the
archived state is lost.
support bundles commands and normally contain archived logs and archived state information of use
to the Cisco TAC. You must ensure that all bundles are retrieved before using this command because the
archived state is lost.