Cisco Cisco Evolved Programmable Network Manager 1.2 Release Notes
4
Cisco Evolved Programmable Network Manager 1.2 Maintenance Pack 6 (V. 1.2.600) Release Notes
Install Cisco EPN Manager 1.2. MP6 (High Availability)
Install Cisco EPN Manager 1.2. MP6 (High Availability)
These are the steps for installing MP6 in a deployment configured with high availability:
Make Sure You Are Starting with the Correct Installed Base (HA Deployment)
Maintenance Pack 6 can only be installed on Cisco EPN Manager 1.2 MP5. In other words:
•
MP6 cannot be installed on Cisco EPN Manager 1.2 (without any maintenance packs).
•
MP6 cannot be installed on Cisco EPN Manager 1.2 that has other MPs installed but not MP5.
•
MP5
release notes
to see the contents of MP5.
Perform these steps to make sure you have the correct installed base before installing MP6.
Step 1
Choose Administration > Licenses and Software Update > Software Update.
Step 2
If Maintenance Pack 5 is listed and its status is “Installed,” you can proceed with the MP6 installation
(go to
(go to
If MP5 is not listed, do not proceed with the MP6 installation. You must install MP5. Please refer to the
release notes
for MP5 for installation instructions.
Verify the HA Configuration on the Servers (HA Deployment)
Step 1
Verify that the primary server is configured correctly for HA.
a.
On the primary server, log in to Cisco EPN Manager as a user with Administrator privileges.
b.
Open the left sidebar, then choose Administration > Settings > High Availability.
c.
Click HA Status on the left, then confirm that the Current State Mode field displays Primary
Active.
Active.
d.
Click HA Configuration on the left, then confirm that the Configuration Mode field displays HA
Enabled.
Enabled.
e.
Confirm that Manual is selected in the Failover Type drop-down list.
Step
Procedure
1.
.
2.
3.
4.