Cisco Headend System Release 2.5
2-12
DNCS Configuration for Distributed BFS
738185 Rev B
Add an Additional BFS QAM to the DNCS,
Continued
Setting Up Additional BFS QAM and MPEG Source Connectivity
Complete these steps to set up the connectivity between the additional BFS QAM
and the MPEG source or associated device.
1.
On the Set Up QAM window, click the Connectivity tab. The Connectivity
tab opens with a graphical representation of the devices already connected to
this QAM (if any).
2.
If not already selected, click the Input Port option in the QAM Name area.
When this option is selected, the button will turn yellow.
3.
In the Connect To area, click the Headend Name arrow and select the
headend that contains the device that is physically connected to this QAM.
4.
Click the Device Type arrow and select the type of device being used to send
data to this QAM (for example, MUX).
Note: We chose MUX as the device type when we added the device to the
Note: We chose MUX as the device type when we added the device to the
DNCS earlier in this section.
Continued on next page