Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide
Chapter 2 Installation and Configuration
added to prevent shorting.
4 Secure the cover to the amplifier module and tighten the amplifier cover screws.
Tighten slotted head screws to 6 in-lb to 9 in-lb (0.7 Nm to 1.0 Nm), or cross head
screws from 18 in-lb to 20 in-lb (2.0 Nm to 2.25 Nm).
Important: The cover should lie completely flat on the amplifier module chassis.
Important: The cover should lie completely flat on the amplifier module chassis.
Make sure none of the amplifier module accessories prevent the cover from lying
flat.
5 Install other options or accessorie。red, or proceed to
Installing the Amplifier
Module (on page 37).
To Install the Plug-in Signal Director
Complete the following steps to install the signal director in the amplifier module.
1 Open the node housing. Refer to
1 Open the node housing. Refer to
To Open the Node Housing (on page 17).
Note: This accessory can be installed without removing the amplifier module
cover.
2 Be sure to install the correct signal director for your system as specified by the
design print.
If you are installing a ...
This will ...
Jumper, part number 4008208
activate only one auxiliary port.
Splitter, part number 4008364
activate both auxiliary ports with equal
signal levels.
8 dB Coupler, part number 4008365 or
12 dB Coupler, part number 4008366
activate both auxiliary ports with differing
signal levels.
3 Install the signal director in the signal director slot. Refer to the following
diagram for the location of the signal director slot.
34
OL-30326-02