Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide
Installing Accessories
Important: Make sure that the signal director is oriented in the proper direction
for your system. Rotating the signal director in the slot will change which ports
are activated with which signal. Refer to the table below to determine the
appropriate orientation for your system installation.
Note: Be sure all the pins on the signal director bottom align with the pin holes
Note: Be sure all the pins on the signal director bottom align with the pin holes
in the signal director slot, allowing the signal director to install flat against the
amplifier module.
4 Install other options or accessories as desired, or proceed to
Installing the
Amplifier Module (on page 37).
Orientation Table
Jumper
To activate the ...
Orient the Jumper ...
AUX 1 port
so that the word "Thru" on the jumper label is next to the
word "AUX 1" on the amplifier module cover.
AUX 2 port
so that the word "Thru" on the jumper label is next to the
word "AUX 2" on the amplifier module cover.
Splitter
To activate the ...
Orient the Splitter ...
AUX 1 port and AUX 2 port so that the word "AUX 1" on the jumper label is next to the
word "AUX 1" on the amplifier module cover, and so that
the word "AUX 2" on the jumper label is next to the word
"AUX 2" on the amplifier module cover.
Important: Do not reverse the Splitter in the signal director slot as this could degrade
OL-30326-02
35