Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Using the FREQ Key Menu
78-545617-01 Rev F
25
Using the FREQ Key Menu
Introduction
Pressing the FREQ key allows you to access the input frequency menu from which
you can change the input frequency.
Setting the Input Frequency
Important! The DNCS overrides any changes made to the input frequency using the
front panel keys if the QPSK demodulator is reset.
Follow these steps to change the input frequency.
1 Press the FREQ key on the front panel of the QPSK demodulator. The Input
Follow these steps to change the input frequency.
1 Press the FREQ key on the front panel of the QPSK demodulator. The Input
Frequency screen appears.
2 Press the Up or Down Arrow keys to increase or decrease the input frequency in
0.250 MHz increments.
Note: The QPSK demodulator supports a frequency range from 5 MHz to 42
Note: The QPSK demodulator supports a frequency range from 5 MHz to 42
MHz.
3 Press ENTER to save changes to nonvolatile memory and return to the Default
Status screen.