Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Chapter 3 Operating the DAVIC QPSK Demodulator
26
78-545617-01 Rev F
Using the STATUS Key Menus
Introduction
Pressing the STATUS key allows you to display QPSK demodulator operating
status.
Reading the STATUS Key Menus
Displays the message Bit Error Rate (BER) only when receiving
burst data
Displays the relative measurement of received signal strength
(RSSI)
Displays the arrival time value of the last burst packet received
Displays the arrival time value of the last burst packet received
Displays the percentage of burst traffic currently going through
the component
Displays the percentage of the microprocessor usage
Displays the current monitor software version
Displays the time and date of the current monitor software
version and its checksum
Displays the first software version
Displays the time and date of the current first software version
and its checksum (verifies that software image is not corrupted)
Displays the current Master (Mstr) Input/Output (I/O) software
version
Displays the time and date of the current master I/O software
Displays the time and date of the current master I/O software
version and its checksum
Displays the first Burst IF software version
Displays the first Burst IF software version
Displays the time and date of the current Burst IF software
version and its checksum
Displays the first Test IF software version
Displays the first Test IF software version
Displays the time and date of the current Test IF software version
and its checksum