Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Installation Guide
Chapter 3 Configuration
24
4024769 Rev A
Result: The handheld terminal attempts to identify the device type of the node.
If recognized, terminal application "HLCM_x_xx_xx.app", software number
013211, is loaded into the handheld terminal's memory and the LCM/node
configuration menu items are available. If the handheld terminal's screen does
not illuminate, make sure that its plug is fully inserted into the local control port
on the module.
Note: If the handheld terminal cannot identify the device type, or cannot find its
associated terminal application, the LCM/node configuration menu items will
not load. Refer to the handheld programming terminal's download kit user
documentation.
If recognized, terminal application "HLCM_x_xx_xx.app", software number
013211, is loaded into the handheld terminal's memory and the LCM/node
configuration menu items are available. If the handheld terminal's screen does
not illuminate, make sure that its plug is fully inserted into the local control port
on the module.
Note: If the handheld terminal cannot identify the device type, or cannot find its
associated terminal application, the LCM/node configuration menu items will
not load. Refer to the handheld programming terminal's download kit user
documentation.
2 Select menu item 1 - RX & TX Config and enter its sub-menu.
a Set receivers RX1 through RX4 and transmitters TX1 through TX4 as Present
or Absent in the node.
3 Select menu item 2 - PS Config and enter its sub-menu.
a Set AC inputs AC1and AC2, plus power supply modules PS1 and PS2 as
Present or Absent in the node.
4 Select menu item 3 - RX Thresholds and enter its sub-menu.
a Set the minimum and maximum power thresholds for receivers RX1 through
RX4.
Note: This sets the switching levels for the two AB switches. The defaults
are 0.5 mW minimum and 1.7 mW maximum.
are 0.5 mW minimum and 1.7 mW maximum.
5 Select menu item 4 - TX Thresholds and enter its sub-menu.
a Set the minimum and maximum power thresholds for transmitters TX1
through TX4.
Note: The defaults are 0.5 mW minimum and 2.3 mW maximum.
6 Select menu item 5 - Node Settings and enter its sub-menu.
a Set the appropriate settings for your installation.
The default settings for 1x/2x Fwd Seg are as follows:
AB Switch 1, AB Switch 2: Preferred A
Reverse Port 1, 2, 4, and 5: On, 0 dB
Forward Seg: 1x/2x Fwd Seg
The default settings for 4x Fwd Seg are as follows:
Reverse Port 1, 2, 4, and 5: On, 0 dB
Forward Seg: 4x Fwd Seg
The default settings for 3xRx1,2,4FS are as follows:
Reverse Port 1, 2, 4, and 5: On, 0 dB