Cisco Headend System Release 2.5 Installation Guide
Reboot a DHCT
4017650 Rev C
187
Reboot a DHCT
Introduction
Occasionally, for troubleshooting or monitoring purposes, you may need to reboot a
DHCT from the DNCS. You can reboot a DHCT from the DNCS using one of the
following methods:
DHCT from the DNCS. You can reboot a DHCT from the DNCS using one of the
following methods:
DHCTs of a specific model number
An individual DHCT
Select from the following procedures according to your system requirements and
current needs.
current needs.
Rebooting DHCTs of a Specific Model Number
Follow these instructions to reboot DHCTs of a specific model number.
1 If necessary, open an xterm window on the DNCS.
2 Type IIH -b -M[model number] and then press Enter.
1 If necessary, open an xterm window on the DNCS.
2 Type IIH -b -M[model number] and then press Enter.
Note: Substitute the model number of DHCT for [model number].
Example: IIH -b -M3375
Result: A confirmation message, similar to the following, appears:
saManager is running
DHCTs with DHCT model=[model number] will be Rebooted
# MAC addresses will be involved.
Do you want to continue (Y/N)?
Example: IIH -b -M3375
Result: A confirmation message, similar to the following, appears:
saManager is running
DHCTs with DHCT model=[model number] will be Rebooted
# MAC addresses will be involved.
Do you want to continue (Y/N)?
3 Type y and then press Enter. The system reboots the specified DHCTs.
Rebooting an Individual DHCT
Follow these instructions to reboot an individual DHCT.
1 If necessary, open an xterm window on the DNCS.
2 Type IIH -b [DHCT MAC address] and then press Enter. The system reboots
1 If necessary, open an xterm window on the DNCS.
2 Type IIH -b [DHCT MAC address] and then press Enter. The system reboots
the specified DHCT.
Notes:
Notes:
Substitute the MAC address of the DHCT for [DHCT MAC address].
The MAC address can be formatted with or without colons ( : ).
Examples:
IIH -b 00:02:DE:A6:45:92
IIH -b 0002DEA64592