Cisco Headend System Release 2.7 Installation Guide
Chapter 2 Installing the Alarm Manager Software
40
78-745262-01Rev C
17 Close any xterm windows or other windows that may be open on the DNCS
desktop.
18 Click EXIT on the toolbar at the bottom of the DNCS screen. A message appears
seeking confirmation of your intent to log out of the DNCS.
Note: You need to log out of the DNCS and then log back in to activate the
Note: You need to log out of the DNCS and then log back in to activate the
modified UNIX environment.
19 Click OK.
Results:
You log out of the DNCS.
The Common Desktop Environment (CDE) Login window opens.
20 Log in to the CDE as dncs user.
21 Verify that the NMI software installed by following these steps.
21 Verify that the NMI software installed by following these steps.
a Open an xterm window.
b Type pkginfo -l SAInmi and then press Enter.
Result: The system displays information pertaining to the NMI software that
b Type pkginfo -l SAInmi and then press Enter.
Result: The system displays information pertaining to the NMI software that
just installed.
22 Wait a few minutes and then begin the
Install the Alarm Manager Server
Software (on page 47) procedure.