Cisco Headend System Release 2.5 Installation Guide
Chapter 5 SR 5.0 Post Upgrade Procedures
88
4035749 Rev B
Session 9: 00:00:00:00:00:02/18
Session 10: 00:00:00:00:00:02/20
Session 11: 00:00:00:00:00:02/22
Session 12: 00:00:00:00:00:02/199
7 Is the system using an ASI BFS?
If yes, in the dncs xterm window, type the following command and press
Enter to display the number of Active Streams on the ASI card.
Enter to display the number of Active Streams on the ASI card.
/opt/solHmux64/vpStatus –d /dev/Hmux0 –P 0
Example:
STATUS: /dev/Hmux0
PORT: 0
MAX BANDWIDTH: 38800000
REMAINING BANDWIDTH: 25800000
TRANSPORT ID: 110
PSI INTERVAL: 80
OPTION SETTINGS:
188 byte packets
Automatic PSI table generation turned ON
ACTIVE STREAMS: 12
ACTIVE TABLE STREAM IDs: 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 0 0
0 0 0
0 0 0 0 0 0 0
If no, and your system is using Multicast, follow this procedure to verify the
number of Multicast sessions.
a On the DNCS WUI, follow this path: DNCS->Network Element
number of Multicast sessions.
a On the DNCS WUI, follow this path: DNCS->Network Element
Provisioning->QAM.
b Click the Filter By Field menu and select All.
c Click Show. All provisioned QAMs are displayed.
d Click the BFS GQAM. The Edit QAM <qam name> WUI appears.
e In the top left corner, click Multicast Sessions. The Multicast Digital
c Click Show. All provisioned QAMs are displayed.
d Click the BFS GQAM. The Edit QAM <qam name> WUI appears.
e In the top left corner, click Multicast Sessions. The Multicast Digital
Session Definition for <qam name> is WUI appears.
f Verify that the number of multicast sessions match the number on the
GQAM.
8 Do the number of sessions match the number of pre-upgrade sesssions?
If yes, continue with Reset the Modulators (on page 92).
If no, execute the procedures in Tear Down BFS and OSM Sessions (on page
88).
88).
Tear Down BFS and OSM Sessions
Complete this procedure ONLY if the number of recovered BFS sessions does not
match the number of pre-upgrade BFS sessions. Complete these steps to tear down
the BFS and OSM sessions in order to return the BFS session count to the expected
number of sessions.
1 Open the Digital Network Control System WebUI.
2 Click Process Status. The Process Status page appears.
match the number of pre-upgrade BFS sessions. Complete these steps to tear down
the BFS and OSM sessions in order to return the BFS session count to the expected
number of sessions.
1 Open the Digital Network Control System WebUI.
2 Click Process Status. The Process Status page appears.